2024 Bush Hog® DSP Series DSP12

Information

2024 Bush Hog® DSP Series DSP12

Bush Hog’s new DSP Line of Pull-Type Drag Scrapers, with standard fixed axle is ideal for moving large quantities of material, leveling, and finish grading. The DSP units come available in 8’, 10’ and 12’ widths. Material can be transferred by dragging it to nearby locations and raising the scraper to deposit the load. Surfaces can be graded and leveled by scraping material from high areas and allowing accumulated material to flow under the grader blade into lower areas. The DSP scrapers are designed for 70 to 125 horsepower tractors and have replaceable wear plates on the sides.

Features may include:

PERFORMANCE
  • Available in 8-foot, 10-foot, and 12-foot widths
  • DSP scrapers are designed for 70 to 125 horsepower tractors
  • Replaceable wear plates on the sides.

Photos

Highlights

  • Virden, Manitoba
  • 2024
  • Bush Hog®
  • DSP Series DSP12
  • Available

Specifications

  • 2024
  • Bush Hog®
  • DSP Series
  • DSP12
  • Graders/Grading Scrapers
  • Rating: 70 TO 125 hp
  • NEW 9.5L X 15 8 PLY RIB TL ON RIM 5 WITH 5.5 BHC
  • Maximun transport: 20 MPH
  • Dump clearance: 21-INCHES | maximum tilt angle: 3 1/2° | tongue construction: 4×4-INCHES X 1/4-INCH TUBING | side plate construction: 3/8×24 5/16-INCHES HIGH X 39 3/4INCHES DEEP | moldboard construction: 1/4-INCH X 24 1/4-INCHES HIGH WHEN FORMED | lift cylinder: 3 1/2-INCHES X 8-INCHES ASAE | tilt cylinder: 3 1/2-INCHES X 8-INCHES ASAE
  • 144 3/16-INCHES
  • 144 3/16-INCHES
  • Of box: 39-INCHES | maximum cutting: 5-INCHES BELOW GRADE | maximum tilit to the right: 8 1/4-INCHES
  • 1/2-INCH X 6-INCHES REVERSIBLE & REPLACEABLE | reinforcement: 3-INCHES X 3-INCHES X 5/16-INCH ANGLE PLUS A 1/4-INCH MOLD BOARD = 9/16-INCH AT THE CUTTING EDGE
  • 2 3/4 CU. YDS.
  • Without material in weight box Tilt Axle: 1700-LB / no tilt axle: 1580-LB / weight of material in weight box: 760-LB